eBay Item # TBD
Description:
- CNC Machined From High Quality 6061 Aluminum
- Installs Between Upper Ball Joint and Upper Control Arm to Correct Upper Control Arm Geometry on Lifted Vehicles = Ability for Proper Alignment. Took my '94 S10 Ext Cab 4.3 V6 with 2.5" coil lift from 3 degrees negative camber back to required 0 degrees camber.
Before -->
After -->
- Superior Design Uses Additional Boss on Top of Spacer to Align Spacer in Control Arm and Reduce Stress on Mounting Bolts. Most Ball Joint Spacers DO NOT Have This Feature - ie. they are flat on top so the long mounting bolts are forced to endure ALL transverse loads that might occur.
Top of
Spacer -->
Bottom of Spacer -->
- Spacer and BJ Installed - Pic From Top
Spacer and BJ Installed
- Pic From Bottom -
Applications:
- Spacer Designed Using TRW P/N 10268 Ball Joint for my '94 Chevy S10 Pickup 4.3L V6 with 2.5" front coil lift
- 1982 - 2003 S10 PICKUP
- 1983 - 1994 S10 BLAZER
- 1995 - 2001 JIMMY
- 1982 - 1990 S15
- 1983 - 1994 S15 JIMMY
- 1991 - 2003 SONOMA
- 1996 - 2000 HOMBRE
- Full Application List for Ball Joint
Pricing:
- $70 Per Pair + Shipping
LIMITED LIFETIME WARRANTY:
- These spacers have a Limited Lifetime Warranty.
- Warranties listed herein only apply to the original purchaser for private, non-commercial use, and only to the vehicle in which the product was originally installed and/or used within provided product was used on a vehicle for which it was designed and under normal operating conditions.
- This warranty does not apply to a) parts which are modified or altered, improperly installed or installed on vehicles for which they were not designed, subjected to misuse, negligence, or vehicular or other accident(s);
- Oligation under this warranty is limited to the repair or replacement of the defective or worn-out products covered by this warranty. NEITHER WARRANTOR NOR MANUFACTURER SHALL BE LIABLE FOR ANY INCIDENTAL OR CONSEQUENTIAL DAMAGES INCLUDING WITHOUT LIMITATION, INDIRECT AND SPECIAL DAMAGES RESULTING FROM DEFECTS IN THE PRODUCT. This warranty does not cover miscellaneous expenses for removal, installation, service, towing or down time, nor does it cover material, labor, or additional parts required for replacement or repair of damages caused by abuse (including fire or wreckage), misuse, neglect, or failure to follow manufacture’s operating and /or installation instructions.
- Buyer is assumed to be the final manufacturer of his or her vehicle. Use this product at your own risk. I assume no responsibility for any damages of any conceivable sort to anything caused or not caused by this product.
-
A front end alignment after
installation of this product
- Camber and toe angles will both be affected and will need to be restored to factory specification with a proper alignment after installing the spacers.
- Custom sizes are available but at buyer's own discretion.
'91-'94 Chevy Lumina Z34 Rear Deck / Trunk Lid
